Brushless Control T 35, T 45, T 60, T 70, T100 - V 2a011, V2a012

 

Brushless Control 35, 45, 60, 70, 100 +T |
#33735, 33745, 33760, 33770, S3030
esc_eng  Version:

V 2a011                   (ESC telemetry)
V 2a012_EAM         (EAM telemetry)
V 2a012_GAM         (GAM telemetry)

Changes:


 V 1a43
- Start-up of governor mode improved
- Delayed beep sound for using the XT-90 connector. XT-90 connector may only be used with the new software.
- Start-up improved

V 1a46
New adjustable via telemetry
- Volume of beeps adjustable from 1 to 5
- Model-search on- and detachable with a beep.
- No motor from beep at -120%

V 1a49 from 23 March 2018
- Improved text telemtry

V 1a46 from 3rd April 2018
- We found a bug in version 1a49 therefore 1a46 is available again.

V 2a010 from 10th October 2018
- improved governor
- SBEC can be buffered with a receiver pack without diode now
- max. rpm is now 180.000rpm for 2 pole motors

V2a011 from 17th November 2018
- governor speed normal instead of highest after factory reset

Specials:

A factory reset should be made after the update

Attention:

Update over Y-cable on 2-pin update cable.
Power supply over the batterie connection of controller

Please enter these characters in the following text field.

The fields marked with * are required.

  • Use Graupner ESCs with Extreme Fligth Xpwr T3910 motor

    I am tryng use Graupner ESCs with Extreme Fligth Xpwr T3910 motor.
    I have tried BRUSHLESS CONTROL +T 60 #33760 and BRUSHLESS CONTROL +T 100 S3030 regs.
    Battery 4S 2700mAh, prop 14x7.
    With both regulators there are the same problem - synchronization fail occurs - screaming sound K-H-R-R-H-H-I-I-!!!, thrust drops, current increases.
    I have set timing to maximim - 25, at lower values disruptions occur more often.
    What other parameters can I try to change to get rid of this?
    In general, does the Graupner regulators compatible with multi-pole (18 in Xpwr T3910) motors?

  • Answer "Use Graupner ESCs with Extreme Fligth Xpwr T3910 motor"

    Hello Erno,

    please program the number of poles and timing for your motor in the controller corretly.

    Kind regards

    Graupner

Related products
BRUSHLESS CONTROL +T70 D3,5 XT-60 BRUSHLESS CONTROL +T70 D3,5 XT-60

Shipping 1-3 workdays

€109.99 *
controller BRUSHLESSCONTROL + T 100 controller BRUSHLESSCONTROL + T 100

Shipping 1-3 workdays

€122.99 *