Brushless Control + T 50 - V 2a013

Brushless Control 50 | #S3046
esc_50_eng  Version: 2a013

Changes:

V 2013 from 05 december 2018

- The governor must be trained with blades, full battery and a regulator opening of> 60%.
- Improved governor
- With throttle -90 ...- 40% a bailout (fast start after autorotation) up to 120 seconds autorotoation is possible
- <-92% throttle is the bailout time as previously only 4 seconds
- With the same controller mouth after the speed has been taught-in, the speed of the 2.00x versions is up to 25% higher than the 1.484 and must therefore be flown again.
- For two or three engine models so that the data from both engines can be captured as ESC, EAM or GAM
- No diode required when connecting a buffer battery
- With the same controller mouth after the speed has been taught-in, the speed of the 2.00x versions is up to 25% higher than the 1.484 and must therefore be flown again.
- improved governor after low load situations in the Heli

Attention:

A factory reset should be made after the update
Update over Y-cable on 2-pole update cable. Power supply over battery connection of the controller.

Please enter these characters in the following text field.

The fields marked with * are required.