Receiver GR-24 HoTT - Version 3a91 & Beta 7a04

GR-24 HoTT | #33512
gr-24_eng  Version:

Version 3a91

Beta Version
Version 7a04

Other downloads: - Handbuch, Manual, Manuel
- Firmware-Upgrade
Changes:

Version 3a90 from 27 June 2017
- Telemetry is faster

Version 7a03 from 08 February 2018
- New: SBUS signal output selectable
- Support for 32 channels channel mapping for mz-32
- Digital switch function for mz-32

Beta-Version 7a04 from 14 February 2018
- Ability to reset lost data packets with mz-32
- Digital switch function now also as level control High/Low at the servo outputs for direct use for LEDs or for direct control of transistors and switches.
SUMD V3 protocol added for the use of 32 channels + 64 switching channels
- SUMDIN Function added for receiver redundancy with SUMD out of a second receiver (at K7) for the receivers GR-16,24,32)

Attention: Default setting period time 10ms for GR-16,24,32

Version 7a04 from 26 February 2018
The version is finally checked and no more a BETA version.

Beta Version 7a04 und 3a91 from 28 March 2018
The receiver software 7a04 is a Beta Software for the radio control mz-32. Our test pilots have carried out numerous tests with the mz-32. During extensive range tests on the ground with the mz-32, a problem has sometimes arisen that first needs to be investigated in more detail. The software can be used in truck function models. Use in flight models is only permitted after successful extensive range tests. Alternative version 3a71 is available. In case of problems with the range test, please send a log file to our Service to email.

Special: The update should be performed with the Firmwareupgrader >3.7.
The update should be performed 2 times.
Thereafter perform a factory reset
Attention:

After the update a factory reset should be performed!
Push and hold the Bind-button then switch the receiver ON and wait about 3 seconds until the LED light up. Release the button.
Without the reset the servos might run to their mechanical end point!

A beta version of a program is an unfinished version that has already passed the alpha stage. Although the program can be used in its basic functions, it has not yet been fully tested for errors. This means that using the beta may cause crashes or bugs.

Tags: GR-24
Please enter these characters in the following text field.

The fields marked with * are required.

  • gr 24

    why do you have to flash receiver twice?

  • Answer "gr-24"

    Hello Goldie,

    a second update is necessary for receiver with old software.

    Kind regards

    Graupner

Related products
GR-24 receiver HoTT GR-24 receiver HoTT

Shipping 1-3 workdays

€112.99 *